What precautions should I take when preparing for shooting GUNPLA videos?
Please refer to the following notes when preparing for filming:
▼ What is a Scan Sheet
Scan Sheet is used as a base when recording GUNPLA. Please print it out before filming.
▼ What is a Scan Marker
The Scan Marker consists of rectangular block parts (rectangular shaped black and white patterns), located outside the scan sheet.
・Please set up the scan sheet on a wide and stable surface that can accommodate the entire scan sheet.
・Place the GUNPLA on top of the scan sheet.
・Position the center of GUNPLA to overlap with the crosshair in the center of the scan sheet.
・When positioning the model, please arrange the GUNPLA so that its contact surface is inside the scan markers.
・When setting up the GUNPLA, make sure that the front of the model aligns with the direction indicated by the 'Front' label printed on the scan sheet.
※The height of the GUNPLA that can be converted into a 3D model must be less than 1 meter from the scan sheet.
※If the GUNPLA larger than the scan sheet, your video may not be able to convert into a 3D model.
If you can not find possible solutions from FAQ, please send your inquiry from below.
Please send your messages regarding our network contents via the following form. We will forward them to the relevant department.
We do not provide individual replies, but your messages will be passed on to the appropriate department.