Q

What are the possible causes of failure in creating a 3D model?
How to Play & Controls

A

The following are possible causes for failure in creating a 3D model:

・The video is filmed without using the scan sheet.
・The scan sheet is creased or bent.
・ GUNPLA that are more than 1 m tall from the scan sheet are being photographed.
・The GUNPLA is not placed in the center of the scan sheet.
・The scan markers are covered by parts like the feet of the GUNPLA.
・The entire scan sheet and GUNPLA are not included within the frame when filming.
・The  accurate scanning is affected by some blind spots in the pose or parts from the camera's perspective.
・While filming, your walking speed may exceed the required pace (the standard is 1 minute per round).
・While filming, the GUNPLA is placed on a turntable to rotate around the camera.
・While filming, your hands are shaky, or the camera moves abruptly up and down.
・The GUNPLA body or accessories (such as beam sabers) have entered the space of the scan markers (including the surrounding airspace).
・Due to the positioning of the GUNPLA or the filming method, some parts of the 3D model may be missing.
※If the generation of the 3D model fails, please avoid re-uploading the same video. Instead, re-film it and upload the new video.

Was this QA useful?
Useful
Couldn't resolve even following the steps.
Q&A content didn't match
Content was outdated
Not helpful (Other reasons)
Inquiries

If you can not find possible solutions from FAQ, please send your inquiry from below.

Support Form
Comments・Requests・Support Messages

Please send your messages regarding our network contents via the following form. We will forward them to the relevant department.
We do not provide individual replies, but your messages will be passed on to the appropriate department.

Comments and Requests
Return to FAQ List Page
Return to Customer Support TOP